SPD 2018 Catalog

2018 Catalog

Issue link: http://read.uberflip.com/i/1014206

Contents of this Issue

Navigation

Page 11 of 91

10 ph. 888-778-3312 www.spdexhaust.com Primary Secondary Major Diameter Minor Diameter (Throat) Major Diameter Minor Diameter Primary Merge Collector Transi on or Straight Tubing Secondary Merge Collector Transi on or Straight Tubing Op onal Straight Tubing Weld Fee Weld Fee Weld Fee Tri-Y (Slip Together) Tri-Y header designs started as a way to build torque in a simple truck and RV header. In recent years, it has been tried in some of the most unlikely racing vehicles and proven to be an effec ve design for almost any naturally aspirated applica on. The benefit is a broader power curve, producing more average horsepower over a given RPM range, resul ng in lower elapsed mes. With enough research and development, a Tri-Y header can reach this goal without sacrificing horsepower compared to a 4 into 1 design. For many applica ons, the costs out weigh the benefits. For some, like a Bonneville racecar, any loss of peak power is too much. We typically recommend Tri-Y's for road racing, off-road trucks, and circle track cars. All of these vehicles are rela vely heavy and require a wide usable RPM range. Designing a Tri-Y header for a compe on engine is not something to take lightly. As previously men oned, if you are star ng from scratch it may take a bit of R&D to design the ideal Tri-Y. There are more variables than you have designing a 4 into 1 system. Choosing the wrong size or length can be more detrimental. We have a lot of experience with Tri-Y's and may be able to guide you in the right direc on or suggest a design for a common engine combina on. The assemblies shown below and on the next page are ordered as a collec on of parts to be incorporated into a new header, not as a bolt on upgrade. We can build the sub-assemblies or a complete fabricated unit as in the case of a welded Tri-Y, but we will need more informa on that just the inlet and (final) outlet sizes. Available Op ons • 12˚, 15˚, 20˚, 25˚ convergent angle • 1.25" and up tube size • 304, 321, 1008 • .065", .049", ( .035" SS only) wall thickness When Ordering, Specify • Throat Size (Minor Diameter) • Outlet Op ons (Flanges, Transi on, Tubing) • Custom Finish Work (Tabs, Bungs, Flanges)

Articles in this issue

Links on this page

view archives of SPD 2018 Catalog - 2018 Catalog