Issue link: http://read.uberflip.com/i/1014206
30 ph. 888-778-3312 www.spdexhaust.com Stub Tubes are available for most flanges by Special Order. Call for details. Face Relieved (Lightened) Call for availability Tube Size Port Size/Shape About Our CNC Machined Flanges Port Shape Number Port Shapes Round ports are machined .020"-.030" over adver sed size. Other shapes are as much as .070" over nominal tube size to allow for easier tube shaping. 1 Rectangle - Longer or wider than wide or high. 2 Round - For stock round ports or oversized tube applica ons. 3 D-Port - Typically flat floor and sides with radius on roof of port. 4 Oval - Two sides half-round. Can be Horizontal or Ver cal oval. Square Oval - Made popular by the 18 0 Chevy. Has Radiused roof and floor. 5 SAP - "Same As Port" - Flange closely matches port shape in cylinder head. 6 Square - Nearly equal height and width with varied corner radius. 7 Counterbored - to accommodate oversized tubing, some flanges have a .150" deep machined step. Our "one of a kind" approach to manufacturing header flanges started small in response to the growing availability of a ermarket heads with unique ports and / or bolt pa erns. With this change in the industry, it became clear that if we were going to build headers that maximized the performance of racing engines, we would first need header flanges specific to those cylinder heads. We are not the only company using CNC machining to produce header flanges, but we are certain that no one else offers more applica ons than SPD. Machined • Precise fit • Clean a rac ve finish • Ready to use. No Burrs, No grinding Laser & Water Jet • Tolerances are harder to hold. • Process typically makes holes that are wider on the back side due to refrac on. Stamped Stamped flanges, on the other hand, are too thin and curled to use when building a quality header. Standards & Op ons Thickness: Standard thickness is 3/8". Most flanges can be special ordered 1/2" thick. Port Size = Tube Size: Sizes shown for port in flange indicates the size tube that can be formed to slip into the flange. Most of our flanges are designed to allow the tube to slip through the flange. Some flanges are available counter- bored to allow oversized tubing while maintaining gasket sealing surface integrity. Materials: Flanges are available in 1018 Cold Rolled Steel, 304 Stainless Steel, or 316 Stainless Steel. Some Stainless Steel flanges are Special Order Only. We recommend 304 SS for high heat applica ons and 316 SS for corrosive environments. Please call for availability. Individual Flanges: Some applica ons have the op on of individual flanges in addi on to the standard 1-piece flange.

