Issue link: http://read.uberflip.com/i/326847
4. Remove all the bolts holding the two bearings onto the conditioner, being careful to prop the auger to prevent it from falling out and hitting something. Remove the auger from the conditioner. 5. Remove the old bearings. Clean the shaft. If the shaft is worn out, replace the auger. 6. Clean out the bearing area inside the conditioner. 8. Install the new bearings, being careful not to damage the bearing. 9. If the machine has the remote grease tubes, remove the grease zerk and install the tubes on the new bearings. 10. Install the auger back into the conditioner sprocket shaft end first and bolt the bearings into place. 11. Reinstall the sprocket and leave it loose so it can be aligned with the motor sprocket then tighten it up. If the sprocket or chain are worn out, replace them. 12. Spin the auger to make sure everything is moving freely. 13. Install conditioner back on machine. 14. Log the hours on the machine and make notes in the ice resurfacer logbook. STARRINKS.COM MAY.JUNE.2014 / 35 , Continued on page 36 These facilities benefit from ARID-Ice desiccant dehumidification for full capacity enhanced humidity control while maintaining automatic indoor air quality. ARID-Ice units are equipped with: • Turbo Vapor Boost ™ reactivation energy control circuitry providing extreme capacity in humid conditions. • State-of-the-art enhanced silica gel desiccant wheel with long lasting seals. • Highly efficient reactivation circuits that deliver dry air on demand maximizing the capability of the ice plant and maintaining a dry building. ARID-Ice by Controlled Dehumidification IMS has provided humidity and indoor air quality control equipment to the Pittsburgh Penguins, New Jersey Devils, Jacksonville Barracudas, Florida Panthers, Houston Aero's, University of Notre Dame and Penn State University to name a few. Over 400 NHL,Triple A, Double A, Collegiate, Recreational Ice Rinks and Curling Clubs Across North America are Fog, Condensation, Mold and Drip Free. Why? They have ARID-Ice ™ . Contact our application specialists to learn how your arena can benefit from ARID-Ice technology. Call 810-229-7900 today. cdims.com Rink_Rink 12/3/13 10:42 AM Page 1 , Always check shaft key on sprockets. Most need to be replaced. 7. , Straighten out the auger if it has bent areas.