Potato Grower

30 POTATO GROWER | SEPTEMBER 2016 Diggin' In Diggin' In Diggin' In Diggin' In Diggin' In Diggin' In What can be done to minimize bruises and wounds this harvest season? There are two major components to bruise management: 1) factoring in tuber conditions and variety susceptibility to bruise with a harvest, and 2) running a handling operation designed to minimize physical impact or damage of the tubers. There are two types of harvest bruises: blackspot and shatter. Two events are involved in blackspot bruise formation: a physical impact, followed by a chemical reaction that causes the discoloration. There is no open wound with blackspot bruising. Conversely, a shatter bruise only needs a physical impact, but that causes a break in the skin or flesh. The level of shatter bruise, or open wounds, can have a huge impact on the potential for disease development and increased weight loss in storage. The pathogens that cause Fusarium dry rot and Pythium leak need a wound to infect the tuber. Pathogens that cause pink rot, late blight, early blight and others may not need a wound, but infection is dramatically increased with wounding. Regardless of the type of wound, economic losses can occur due to disease invasion, shrinkage and discoloration. A key bruise management strategy is to factor in tuber conditions while minimizing impacts from equipment operation to successfully reduce bruise potential. TUBER CONDITION Tuber temperature, hydration level (crispness) and maturity interact to influence bruise susceptibility. In general, the lower the pulp temperature, the more susceptible tubers are to both shatter and blackspot bruising. Pulp temperatures below 45 degrees Fahrenheit make it HARVEST| By Nora Olsen and Mike Thornton, University of Idaho Managing bruising during harvest Battered and Bruised very difficult to handle potatoes without causing significant shatter bruise damage. The more hydrated or crisp the potatoes are, the greater the susceptibility to shatter bruise. In contrast, dehydrated potatoes are susceptible to blackspot bruise. Likewise, as plants mature, the tubers become more susceptible to blackspot bruise. Tubers that sit in dry soil under dead or dying vines can become very susceptible to blackspot. Knowledge of the relative bruise susceptibility of different potato varieties allows the use of tuber hydration level to your advantage. For example, Bannock Russet is known to be relatively susceptible to shatter bruise but resistant to blackspot. Therefore, it is recommended that Bannock fields be harvested under slightly drier conditions to reduce shatter bruise. Another example is the use of green-digging Ranger Russet tubers to lessen blackspot bruise development. HARVESTER AND HANDLING OPERATION The more susceptible tubers are to damage, the more important it is to operate the harvester under optimum conditions. Achieving optimum harvester operation requires reducing drops, cushioning impact areas, and setting chain speeds in relation to ground speed so that harvester chains are filled to capacity. If the volume of material (tubers and soil) passing over each chain can be matched to the capacity of that chain, damage due to excess tuber movement, rollback and drops can all be reduced. It has been reported that about 30 percent of all bruise damage found on tubers in storage occurs after contact with the harvester. Bruise reduction during the trucking and piling operations requires minimizing drops, matching conveyor speed to tuber volume, and piling in a progressive, stepwise fashion During harvest, the handling operation should be designed to minimize impact and damage to tubers.

• Cover