Installation Guide

Big data Cumulus-Linux installation guide

Issue link: https://read.uberflip.com/i/1123828

Contents of this Issue

Navigation

Page 13 of 26

B I G D AT A AN D C U MU L U S L I NU X : V AL I DA T E D DE SI G N GU I D E 14 isisd=no babeld=no Next, provide Quagga with its own configuration file. Create a new /etc/quagga/Quagga.conf file with the following: password PASSWORD enable password PASSWORD ! interface swp49 ip ospf network point-to-point ip ospf area 0.0.0.0 ! interface swp50 ip ospf network point-to-point ip ospf area 0.0.0.0 ! interface bridge ip ospf area 0.0.0.0 ! router ospf auto-cost reference-bandwidth 40000 ospf router-id 10.2.1.1 passive-interface default no passive-interface swp49 no passive-interface swp50 Once these interfaces have been created, apply the configuration by restarting the network services or individually bringing up the new interfaces: cumulus@switch:~$ sudo service quagga restart 4. Configure Spine Switches Define the interfaces you will use on each switch and their roles. Open your /etc/network/interfaces file and add the following sections: # Active ports <% spine-ports = [1,2,3,4,5,6,7,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,25,26,27,28,29,3 0,31,32] %>

Articles in this issue

view archives of Installation Guide - Big data Cumulus-Linux installation guide