Issue link: https://read.uberflip.com/i/1428362
LoRaWAN 1.0.2 Regional Parameters ©2017 LoRa Alliance™ Page 9 of 55 The authors reserve the right to change specifications without notice. Modulation Bandwidth [kHz] Channel Frequency [MHz] FSK Bitrate or LoRa DR / Bitrate Nb Channels LoRa 125 868.10 868.30 868.50 DR0 – DR5 / 0.3-5 kbps 3 Table 3: EU863-870 JoinReq Channel List 289 2.1.3 EU863-870 Data Rate and End-device Output Power encoding 290 There is no dwell time limitation for the EU863-870 PHY layer. The TxParamSetupReq 291 MAC command is not implemented in EU863-870 devices. 292 The following encoding is used for Data Rate (DR) and End-device EIRP (TXPower) in the 293 EU863-870 band: 294 295 DataRate Configuration Indicative physical bit rate [bit/s] 0 LoRa: SF12 / 125 kHz 250 1 LoRa: SF11 / 125 kHz 440 2 LoRa: SF10 / 125 kHz 980 3 LoRa: SF9 / 125 kHz 1760 4 LoRa: SF8 / 125 kHz 3125 5 LoRa: SF7 / 125 kHz 5470 6 LoRa: SF7 / 250 kHz 11000 7 FSK: 50 kbps 50000 8..15 RFU Table 4: TX Data rate table 296 297 EIRP 1 refers to the Equivalent Isotropically Radiated Power, which is the radiated output 298 power referenced to an isotropic antenna radiating power equally in all directions and whose 299 gain is expressed in dBi. 300 TXPower Configuration (EIRP) 0 MaxEIRP 1 MaxEIRP – 2dB 2 MaxEIRP – 4dB 3 MaxEIRP – 6dB 4 MaxEIRP – 8dB 5 MaxEIRP – 10dB 6 MaxEIRP – 12dB 7 MaxEIRP – 14dB 8..15 RFU Table 5: TX power table 301 302 303 304 1 ERP = EIRP – 2.15dB; it is referenced to a half-wave dipole antenna whose gain is expressed in dBd