Document

LoRaWAN® Specification v1.0

Issue link: https://read.uberflip.com/i/1428377

Contents of this Issue

Navigation

Page 33 of 81

LoRaWAN Specification ©2015 LoRa™ Alliance Page 34 of 82 The authors reserve the right to change specifications without notice. 7 Physical Layer 1 7.1 EU 863-870MHz ISM Band 2 7.1.1 EU863-870 Preamble Format 3 The following synchronization words should be used: 4 5 Modulation Sync word Preamble length LORA 0x34 8 symbols GFSK 0xC194C1 5 bytes Table 11: EU863-870 synch words 6 7.1.2 EU863-870 ISM Band channel frequencies 7 In Europe, radio spectrum allocation is the ISM band is defined by ETSI [EN300.220]. 8 The network channels can be freely attributed by the network operator. However the three 9 following default channels must be implemented in every EU868MHz end-device. Those 10 channels are the minimum set that all network gateways should always be listening on. 11 12 Modulation Bandwidth [kHz] Channel Frequency [MHz] FSK Bitrate or LoRa DR / Bitrate Nb Channels Duty cycle LoRa 125 868.10 868.30 868.50 DR0 to DR5 / 0.3-5 kbps 3 <1% Table 12: EU863-870 default channels 13 In order to access the physical medium the ETSI regulations impose some restrictions such 14 maximum time the transmitter can be on or the maximum time a transmitter can transmit per 15 hour. The ETSI regulations allow the choice of using either a duty-cycle limitation or a so- 16 called Listen Before Talk Adaptive Frequency Agility (LBT AFA) transmissions 17 management. The current LoRaWAN specification exclusively uses duty-cycled limited 18 transmissions to comply with the ETSI regulations. 19 The LoRaWAN enforces a per sub-band duty-cycle limitation. Each time a frame is 20 transmitted in a given sub-band, the time of emission and the on-air duration of the frame 21 are recorded for this sub-band. The same sub-band cannot be used again during the next 22 Toff seconds where: 23 During the unavailable time of a given sub-band, the device may still be able to transmit on 24 another sub-band. If all sub-bands are unavailable, the device has to wait before any further 25 transmission. The device adapts its channel hoping sequence according to the sub-band 26 availability. 27 Example: A device just transmitted a 0.5 s long frame on one default channel. This channel 28 is in a sub-band allowing 1% duty-cycle. Therefore this whole sub-band (868 – 868.6) will be 29 unavailable for 49.5 s. 30

Articles in this issue

view archives of Document - LoRaWAN® Specification v1.0