Document

LoRaWAN® Specification v1.0

Issue link: https://read.uberflip.com/i/1428377

Contents of this Issue

Navigation

Page 75 of 81

LoRaWAN Specification ©2015 LoRa™ Alliance Page 76 of 82 The authors reserve the right to change specifications without notice. 18.4 Data-Rate Adaptation during Message Retransmissions 1 When an end-device attempts the transmission of a ―confirmed' frame toward the network it 2 expects to receive an acknowledgement in one of the subsequent reception slot. In the 3 absence of the acknowledgement it will try to re-transmit the same data again. This re- 4 transmission happens on a new frequency channel, but can also happen at a different data 5 rate (preferable lower) than the previous one. It is strongly recommended to adopt the 6 following re-transmission strategy. 7 The first transmission of the ―confirmed‖ frame happens with a data rate DR. 8 9 Transmission nb Data Rate 1 (first) DR 2 DR 3 max(DR-1,0) 4 max(DR-1,0) 5 max(DR-2,0) 6 max(DR-2,0) 7 max(DR-3,0) 8 max(DR-3,0) The Data Rate max(a,b) stands for maximum of a and b values. 10 If after a recommended 8 transmissions, the frame has not been acknowledged the MAC 11 layer should return an error code to the application layer. 12 Note: For each re-transmission, the frequency channel is selected 13 randomly as for normal transmissions. 14 Any further transmission uses the last data rate used. 15 For example if an end-device sends a ―confirmed‖ frame first using DR5 and has to 16 retransmit 3 times (twice at DR5 then twice at DR4), the next frame transmitted will use DR4 17 Other example, if an end-device sends a ―confirmed‖ frame first using DR5 and does not 18 receive an acknowledge after 8 transmissions (2 at DR5, 2 at DR4, … , 2 at DR2), and the 19 application of this end-device re-initiates a ―confirmed‖ transmission a little later, the first two 20 transmission will be tentatively at DR2, then switch to DR1, then to DR0. 21

Articles in this issue

view archives of Document - LoRaWAN® Specification v1.0