Document

LoRaWAN® Specification v1.0

Issue link: https://read.uberflip.com/i/1428377

Contents of this Issue

Navigation

Page 12 of 81

LoRaWAN Specification ©2015 LoRa™ Alliance Page 13 of 82 The authors reserve the right to change specifications without notice. 1 Figure 4: End-device receive slot timing. 2 3.3.1 First receive window channel, data rate, and start 3 The first receive window RX1 uses the same frequency channel as the uplink and a data 4 rate that is a function of the data rate used for the uplink. RX1 opens RECEIVE_DELAY1 1 5 seconds (+/- 20 microseconds) after the end of the uplink modulation. The relationship 6 between uplink and RX1 slot downlink data rate is region specific and detailed in the Section 7 7. By default the first receive window datarate is identical to the datarate of the last uplink. 8 3.3.2 Second receive window channel, data rate, and start 9 The second receive window RX2 uses a fixed configurable frequency and data rate and 10 opens RECEIVE_DELAY2 1 seconds (+/- 20 microseconds) after the end of the uplink 11 modulation. The frequency and data rate used can be modified through MAC commands 12 (see Section 5).The default frequency and data rate to use are region specific and detailed 13 in the Section 7 . 14 3.3.3 Receive window duration 15 The length of a receive window must be at least the time required by the end-device's radio 16 transceiver to effectively detect a downlink preamble. 17 3.3.4 Receiver activity during the receive windows 18 If a preamble is detected during one of the receive windows, the radio receiver stays active 19 until the downlink frame is demodulated. If a frame was detected and subsequently 20 demodulated during the first receive window and the frame was intended for this end-device 21 after address and MIC (message integrity code) checks, the end-device does not open the 22 second receive window. 23 3.3.5 Network sending a message to an end-device 24 If the network intends to transmit a downlink to an end-device, it will always initiate the 25 transmission precisely at the beginning of one of those two receive windows. 26 1 RECEIVE_DELAY1 and RECEIVE_DELAY2 are described in Chapter 6.

Articles in this issue

view archives of Document - LoRaWAN® Specification v1.0