Issue link: https://read.uberflip.com/i/1428377
LoRaWAN Specification ©2015 LoRa™ Alliance Page 18 of 82 The authors reserve the right to change specifications without notice. (i.e., after a total of ADR_ACK_LIMIT + ADR_ACK_DELAY), the end-device may try to 1 regain connectivity by switching to the next lower data rate that provides a longer radio 2 range. The end-device will further lower its data rate step by step every time 3 ADR_ACK_LIMIT is reached. The ADRACKReq shall not be set if the device uses its 4 default data rate because in that case no action can be taken to improve the link range. 5 Note: Not requesting an immediate response to an ADR 6 acknowledgement request provides flexibility to the network to 7 optimally schedule its downlinks. 8 9 Note: In uplink transmissions the ADRACKReq bit is set if 10 ADR_ACK_CNT >= ADR_ACK_LIMIT and the current data-rate is 11 greater than the device defined minimum data rate, it is cleared in 12 other conditions. 13 4.3.1.2 Message acknowledge bit and acknowledgement procedure (ACK in FCtrl) 14 When receiving a confirmed data message, the receiver shall respond with a data frame that 15 has the acknowledgment bit (ACK) set. If the sender is an end-device, the network will send 16 the acknowledgement using one of the receive windows opened by the end-device after the 17 send operation. If the sender is a gateway, the end-device transmits an acknowledgment at 18 its own discretion. 19 Acknowledgements are only sent in response to the latest message received and are never 20 retransmitted. 21 22 Note: To allow the end-devices to be as simple as possible and have 23 as few states as possible it may transmit an explicit (possibly empty) 24 acknowledgement data message immediately after the reception of a 25 data message requiring a confirmation. Alternatively the end-device 26 may defer the transmission of an acknowledgement to piggyback it 27 with its next data message. 28 4.3.1.3 Retransmission procedure 29 The number of retransmissions (and their timing) for the same message where an 30 acknowledgment is requested but not received is at the discretion of the end device and 31 may be different for each end-device, it can also be set or adjusted from the network server. 32 Note: Some example timing diagrams of the acknowledge mechanism 33 are given in Chapter 18. 34 35 Note: If an end-device has reached its maximum number of 36 retransmissions without receiving an acknowledgment, it can try to re- 37 gain connectivity by moving to a lower data rate with longer reach. It is 38 up to the end-device to retransmit the message again or to forfeit that 39 message and move on. 40 41 Note: If the network server has reached its maximum number of 42 retransmissions without receiving an acknowledgment, it will generally 43 consider the end-device as unreachable until it receives further 44
