Issue link: https://read.uberflip.com/i/1428377
LoRaWAN Specification ©2015 LoRa™ Alliance Page 25 of 82 The authors reserve the right to change specifications without notice. The LinkADRAns Status bits have the following meaning: 1 2 Bit = 0 Bit = 1 Channel mask ACK The channel mask sent enables a yet undefined channel. The command was discarded and the end- device state was not changed. The channel mask sent was successfully interpreted. All currently defined channel states were set according to the mask. Data rate ACK The data rate requested is unknown to the end-device or is not possible given the channel mask provided (not supported by any of the enabled channels). The command was discarded and the end-device state was not changed. The data rate was successfully set. Power ACK The requested power level is not implemented in the device. The command was discarded and the end- device state was not changed. The power level was successfully set. Table 6: LinkADRAns status bits signification 3 If any of those three bits equals 0, the command did not succeed and the node has kept the 4 previous state. 5 5.3 End-Device Transmit Duty Cycle (DutyCycleReq, DutyCycleAns) 6 The DutyCycleReq command is used by the network coordinator to limit the maximum 7 aggregated transmit duty cycle of an end-device. The aggregated transmit duty cycle 8 corresponds to the transmit duty cycle over all sub-bands. 9 10 Size (bytes) 1 DutyCycleReq Payload MaxDCycle 11 The maximum end-device transmit duty cycle allowed is: 12 The valid range for MaxDutyCycle is [0 : 15]. A value of 0 corresponds to ―no duty cycle 13 limitation‖ except the one set by the regional regulation. 14 A value of 255 means that the end-device shall become silent immediately. It is equivalent to 15 remotely switching off the end-device. 16 An end-device answers to a DutyCycleReq with a DutyCycleAns command. The 17 DutyCycleAns MAC reply does not contain any payload. 18
