Document

LoRaWAN® Specification v1.0.1

Issue link: https://read.uberflip.com/i/1428386

Contents of this Issue

Navigation

Page 25 of 90

LoRaWAN Specification ©2016 LoRa™ Alliance Page 26 of 91 The authors reserve the right to change specifications without notice. An end-device answers to a DutyCycleReq with a DutyCycleAns command. The 1 DutyCycleAns MAC reply does not contain any payload. 2 5.4 Receive Windows Parameters (RXParamSetupReq, 3 RXParamSetupAns) 4 The RXParamSetupReq command allows a change to the frequency and the data rate set 5 for the second receive window (RX2) following each uplink. The command also allows to 6 program an offset between the uplink and the RX1 slot downlink data rates. 7 8 Size (bytes) 1 3 RXParamSetupReq Payload DLsettings Frequency 9 Bits 7 6:4 3:0 DLsettings RFU RX1DRoffset RX2DataRate 10 The RX1DRoffset field sets the offset between the uplink data rate and the downlink data 11 rate used to communicate with the end-device on the first reception slot (RX1). As a default 12 this offset is 0. The offset is used to take into account maximum power density constraints 13 for base stations in some regions and to balance the uplink and downlink radio link margins. 14 The data rate (RX2DataRate) field defines the data rate of a downlink using the second 15 receive window following the same convention as the LinkADRReq command (0 means 16 DR0/125kHz for example). The frequency (Frequency) field corresponds to the frequency of 17 the channel used for the second receive window, whereby the frequency is coded following 18 the convention defined in the NewChannelReq command. 19 The RXParamSetupAns command is used by the end-device to acknowledge the reception 20 of RXParamSetupReq command. The RXParamSetupAns command should be added in 21 the FOpt field of all uplinks until a class A downlink is received by the end-device. This 22 guarantees that even in presence of uplink packet loss, the network is always aware of the 23 downlink parameters used by the end-device. 24 The payload contains a single status byte. 25 Size (bytes) 1 RXParamSetupAns Payload Status 26 The status (Status) bits have the following meaning. 27 Bits 7:3 2 1 0 Status bits RFU RX1DRoffset ACK RX2 Data rate ACK Channel ACK 28 Bit = 0 Bit = 1 Channel ACK The frequency requested is not usable by the end- device. RX2 slot channel was successfully set RX2 Data rate ACK The data rate requested is unknown to the end-device. RX2 slot data rate was successfully set RX1DRoffset ACK the uplink/downlink data rate offset for RX1 slot is not in the allowed range RX1DRoffset was successfully set Table 7: RX2SetupAns status bits signification 29

Articles in this issue

view archives of Document - LoRaWAN® Specification v1.0.1