LoRa Alliance
5177 Brandin Court,
Fremont, CA 94538 USA
LoRaWAN 1.0.4 End Device Certification Page 161 of 173
Requirements for All Regions Version 1.4
Copyright © 2021 LoRa Alliance, Inc. All rights reserved. www.lora-alliance.org
TCL also sends Unconfirmed frame
MAC-CMD1 DevStatusReq
MAC-CMD2
RxParamSetupReq
Repeat the MAC-CMD
DevStatusReq until the MAC
command uplink response
buffer would be full for
MinDR, refer [2] (i.e. same
number of DevStatusReq
commands sent in the
previous step)
MAC-CMDX LinkADRReq
(with DataRate =
Max125kHzDR)
Payload =
[0x]06[0x]05XXXXXXXX[0x]0
6[Repeat as
required][0x]03XXXXXXXX
For FC
device using
8-channel
gateway,
refer to
Section 2 for
ChMask
settings
6 DUT sends Unconfirmed frame
→
DataRate = Max125kHzDR
MAC-CMD1 DevStatusAns
MAC-CMD2
RxParamSetupAns
MAC-CMD3 DevStatusAns
…
MAC-CMDX DevStatusAns
MAC-CMDX+1 LinkADRAns
Payload =
[0x]06XXXX[0x]0507[0x]06X
XXX…[0x]06XXXX[0x]0307
DUT must not truncate the
frame.
Successful
completion of
all
commands.
Message is
not truncated.
3. FPort 224 Deactivation 1321
This test must be performed as the last step ever to be performed on the device. The test lab 1322
must ensure that all other tests are completed on the device before performing this test. When 1323
the FPort 224 is disabled, it cannot be re-enabled on the device again. 1324
1325
The TCL will send a downlink payload message of [0x]07E (DutFPort224DisableReq) over port 1326
224, thus disabling FPort 224 for the DUT. 1327
1328
3.1. Test Procedure Message Sequence Chart 1329
1330
1331
1332
