PRE OPERATION
1. Prepare the workspace: clear the table except for workpiece or stock.
2. Secure the workpiece: use a clamp or vise to prevent spinning.
3. Adjust table and work stop: set to correct height and position and lock them in.
4. Check the bit: lock drill bit in chuck; remove and secure chuck key.
5. Shield the spindle: position the guard over the point of operation.
6. Set speed: match drill speed to material type.
DURING OPERATION
1. Drill carefully: lower spindle slowly using the hand lever. Lubricate drill bit as needed.
2. Start small: drill a pilot hole before enlarging.
3. Ease through: reduce force as the bit breaks through the material.
4. Keep hands clear: stay away from spindle and drill area. Never reach around or under.
REQUIRED PPE
Safety Glasses Hearing Protection
Always wear all required PPE
PRECAUTIONS
1. Inspect equipment - Do not use if equipment is damaged.
2. Inspect guards/shields - Do not use if guards/shields are missing or damaged.
3. Keep drill bits clean and sharp.
4. Secure long hair, ensure no loose clothing, remove jewelry, no gloves while
machine is in operation.
HAZARDS
Cuts
Entanglement
Dust
Burns
Noise
Pinch point
Flying debris
Kickback
Report any issues or findings to your supervisor immediately
!
Only use equipment if you are trained and authorised to do so.
Refer to user manual for additional information including set up, maintenance and instructions for use.
WSPS.CA
DRILL PRESS SAFE WORK PROCEDURE
