PRE OPERATION
1. Prepare the workspace: clear the table except for workpiece or stock.
2. Install drill bit and chisel:
a. Insert both chisel and drill bit into the bushing, so that drill bit is in the chuck.
b. Place a thin 'spacer' between the chisel and bushing.
c. Use a wooden block to push both upward fully, and tighten the drill bit chuck.
d. Remove spacer, push chisel up as far as it will go and tighten the chisel locking screw. This creates
the appropriate clearance of the drill bit to chisel (1/16
th
to 3/16
th
depending on wood type).
Remove chuck key.
3. Square the chisel: loosen the chisel locking screw, align chisel to fence, and retighten.
4. Set the depth: adjust the depth stop to achieve desired chisel cut depth.
5. Position the worktable: adjust forwards/backwards, left/right based on needs and lock in place.
6. Secure the workpiece: place workpiece on the table against the fence and use a clamp or vise to hold
workpiece (as required).
REQUIRED PPE
Safety Glasses Hearing Protection
Always wear all required PPE
PRECAUTIONS
1. Inspect equipment - Do not use if equipment is damaged.
2. Inspect guards/shields - Do not use if guards/shields are missing or
damaged.
3. Keep drill bits clean and sharp.
4. Tie back long hair, ensure no loose clothing, remove jewelry, no gloves.
HAZARDS
Cuts
Entanglement
Dust
Burns
Noise
Pinch Point
Flying debris
Kickback
Report any issues or findings to your supervisor immediately
!
Only use equipment if you are trained and authorised to do so.
Refer to user manual for additional information including set up, maintenance and instructions for use.
WSPS.CA
MORTISER SAFE WORK PROCEDURE
