PRE OPERATION
1. Secure mitre saw: make sure the saw is secured to work area and does not wobble or move.
2. Prepare the workspace: clear the table except for the workpiece or stock, check stock for debris, nails or screws,
ensure floor is clean, dry and free of tripping hazards.
3. Set blade angles: set correct angles and locking mechanisms for mitre or bevel cuts.
4. Set blade depth stop: if equipped, set the depth control mechanism to the desired depth.
5. Align with the fence: use the fence position to guide the work, using an approved spacer if needed.
6. Secure the workpiece: use a clamp for the workpiece, support longer stock with stands or rollers.
7. Start dust collection: turn it on before powering up the saw and starting the cut.
REQUIRED PPE
Safety Glasses Hearing Protection Dust Mask or
Respirator
Protective Work
Boots
Always wear all required PPE
PRECAUTIONS
1. Inspect equipment - Do not use if equipment is damaged.
2. Inspect guards/shields - Do not use if guards/shields are missing or damaged.
3. Inspect material, ensure it is free of nails, screws or debris. Do not cut
unapproved materials such as steel.
4. Secure long hair, ensure no loose clothing, remove jewelry, no gloves while
machine is in operation.
HAZARDS
Cuts
Entanglement
Dust
Burns
Noise
Pinch point
Flying debris
Kickback
Amputations
Report any issues or findings to your supervisor immediately
!
Only use equipment if you are trained and authorised to do so.
Refer to user manual for additional information including set up, maintenance and instructions for use.
WSPS.CA
MITRE SAW SAFE WORK PROCEDURE
