PRE OPERATION
1. Inspect the workpiece: inspect for loose knots, splits, defects and foreign objects.
2. Prepare the workspace: clear the table except for the workpiece or stock.
3. Check blade tension and alignment: ensure blade tension is tight and blade alignment is straight.
4. Adjust moveable blade guard: adjust blade guard to a height within close proximity to the workpiece.
5. Check the blade: use the proper blade for the type of work and ensure it is sharp and undamaged.
6. Start the dust collector: turn on the dust collection system and ensure its working appropriately.
REQUIRED PPE
Safety Glasses Hearing Protection
Always wear all required PPE
PRECAUTIONS
1. Inspect equipment - Do not use if equipment is damaged.
2. Inspect guards/shields - Do not use if guards/shields are missing or damaged.
3. Keep sanding pads clean.
4. Tie back long hair, ensure no loose clothing, remove jewelry, no gloves during
operation.
HAZARDS
Cuts
Entanglement
Dusts
Burns
Noise
Pinch point
Flying debris
Kickback
Report any issues or findings to your supervisor immediately
!
Only use equipment if you are trained and authorised to do so.
Refer to user manual for additional information including set up, maintenance and instructions for use.
WSPS.CA
VERTICAL BANDSAW
SAFE WORK PROCEDURE
