Guides & Toolkits

1 330-CGO-01-IMDO © 2026, Workplace Safety & Prevention Services (WSPS) 1 877 494 WSPS (9777) | 905 614 1400 | WSPS.CA SAFETY STANDARD: BELT SANDER A B C D E HAZARD/INJURY RISK POTENTIAL SOLUTIONS REGULATORY REFERENCES A Contact with unused portions of the abrasive. Ensure adjustable shields are in place and positioned based on workpiece prior to use. Use locking pliers or another holding device to keep fingers away if using small workpieces. Sec. 25 (1)(a),(b),(d) OHSA Sec. 25 (2)(a),(d),(h) OHSA Sec. 25, Reg. 851 B The motor on the sander can create entanglement hazards. Long hair, loose clothing and/or jewelry can be drawn into the machine. Install fixed guarding to prevent access if the motor drive shaft is exposed.Ensure the drive cover/guard is secured in place with a tool-tight fastener to restrict access. Before use, remove loose clothing and jewelry, and tie back long hair to reduce the risk of entanglement. Position table according to operator manual to maintain the proper gap from the sanding belt. Do not wear gloves when operating the belt sander. Sec. 25 (1)(a),(b),(d) OHSA Sec. 25 (2)(a),(d),(h) OHSA Sec. 24, 83, Reg. 851 C Gaps at the belt pulleys or a gap between worktable and abrasive may present in-running nip and/or entanglement hazards. Ensure guarding is in place around the pulleys. Ensure table is positioned according to the manufacturer's instructions. Allow abrasive to cool before handling. Sec. 25 (1)(a) OHSA Sec. 25 (2)(h) OHSA Sec. 25, Reg. 851 D The abrasive surface can become very hot, especially when sanding large pieces or running the sander for long periods. Potential for a fire hazard when working with combustible materials. Ensure abrasive is not contacted with bare skin. Allow abrasive to cool before handling. Only use with approved materials as per manufacturer directions. Sec. 25 (2)(h) OHSA E Debris from the workpiece can be thrown toward the operator during sanding, and worn sanding media may also cause material to be ejected. Use protective eyewear and or face shield. Follow machine and tool maintenance recommendations from the manufacturer Prior to using the sander, check workpiece for nails, staples, knots, or other defects Do not sand wet materials. Only use on approved materials as per manufacturer directions Sec. 25 (1)(a),(d) OHSA Sec. 25 (1)(b),(b.1) OHSA Sec. 25 (2)(a),(d),(h) OHSA F Sanding produces fine dust which is an inhalation hazard. Ensure dust port is connected to a suitable dust collection system. Sec. 25 (1)(b) OHSA G H F

• Cover