Issue link: https://read.uberflip.com/i/1428386
LoRaWAN Specification ©2016 LoRa™ Alliance Page 13 of 91 The authors reserve the right to change specifications without notice. 3 Physical Message Formats 1 The LoRa terminology distinguishes between uplink and downlink messages. 2 3.1 Uplink Messages 3 Uplink messages are sent by end-devices to the network server relayed by one or many 4 gateways. 5 Uplink messages use the LoRa radio packet explicit mode in which the LoRa physical 6 header (PHDR) plus a header CRC (PHDR_CRC) are included. 1 The integrity of the payload 7 is protected by a CRC. 8 The PHDR, PHDR_CRC and payload CRC fields are inserted by the radio transceiver. 9 Uplink PHY: 10 Preamble PHDR PHDR_CRC PHYPayload CRC Figure 2: Uplink PHY structure 11 3.2 Downlink Messages 12 Each downlink message is sent by the network server to only one end-device and is 13 relayed by a single gateway. 2 14 Downlink messages use the radio packet explicit mode in which the LoRa physical header 15 (PHDR) and a header CRC (PHDR_CRC) are included. 3 16 Downlink PHY: 17 Preamble PHDR PHDR_CRC PHYPayload Figure 3: Downlink PHY structure 18 3.3 Receive Windows 19 Following each uplink transmission the end-device opens two short receive windows. The 20 receive window start times are defined using the end of the transmission as a reference. 21 22 23 Figure 4: End-device receive slot timing. 24 1 See the LoRa radio transceiver datasheet for a description of LoRa radio packet implicit/explicit modes. 2 This specification does not describe the transmission of multicast messages from a network server to many end-devices. 3 No payload integrity check is done at this level to keep messages as short as possible with minimum impact on any duty-cycle limitations of the ISM bands used.
