Issue link: https://read.uberflip.com/i/1428386
LoRaWAN Specification ©2016 LoRa™ Alliance Page 14 of 91 The authors reserve the right to change specifications without notice. 3.3.1 First receive window channel, data rate, and start 1 The first receive window RX1 uses a frequency that is a function of the uplink frequency and 2 a data rate that is a function of the data rate used for the uplink. RX1 opens 3 RECEIVE_DELAY1 1 seconds (+/- 20 microseconds) after the end of the uplink modulation. 4 The relationship between uplink and RX1 slot downlink data rate is region specific and 5 detailed in the Section 7. By default the first receive window datarate is identical to the 6 datarate of the last uplink. 7 3.3.2 Second receive window channel, data rate, and start 8 The second receive window RX2 uses a fixed configurable frequency and data rate and 9 opens RECEIVE_DELAY2 1 seconds (+/- 20 microseconds) after the end of the uplink 10 modulation. The frequency and data rate used can be modified through MAC commands 11 (see Section 5).The default frequency and data rate to use are region specific and detailed 12 in the Section 7 . 13 3.3.3 Receive window duration 14 The length of a receive window must be at least the time required by the end-device's radio 15 transceiver to effectively detect a downlink preamble. 16 3.3.4 Receiver activity during the receive windows 17 If a preamble is detected during one of the receive windows, the radio receiver stays active 18 until the downlink frame is demodulated. If a frame was detected and subsequently 19 demodulated during the first receive window and the frame was intended for this end-device 20 after address and MIC (message integrity code) checks, the end-device does not open the 21 second receive window. 22 3.3.5 Network sending a message to an end-device 23 If the network intends to transmit a downlink to an end-device, it will always initiate the 24 transmission precisely at the beginning of one of those two receive windows. 25 3.3.6 Important notice on receive windows 26 An end-device shall not transmit another uplink message before it either has received a 27 downlink message in the first or second receive window of the previous transmission, or the 28 second receive window of the previous transmission is expired. 29 3.3.7 Receiving or transmitting other protocols 30 The node may listen or transmit other protocols or do any transactions between the 31 LoRaWAN transmission and reception windows, as long as the end-device remains 32 compatible with the local regulation and compliant with the LoRaWAN specification. 33 1 RECEIVE_DELAY1 and RECEIVE_DELAY2 are described in Chapter 6.
