Document

LoRaWAN® Specification v1.0.1

Issue link: https://read.uberflip.com/i/1428386

Contents of this Issue

Navigation

Page 22 of 90

LoRaWAN Specification ©2016 LoRa™ Alliance Page 23 of 91 The authors reserve the right to change specifications without notice. It is therefore advisable to order MAC commands according to the 1 version of the LoRaWAN specification which has introduced a MAC 2 command for the first time. This way all MAC commands up to the 3 version of the LoRaWAN specification implemented can be processed 4 even in the presence of MAC commands specified only in a version of 5 the LoRaWAN specification newer than that implemented. 6 7 Note: Any values adjusted by the network server (e.g., RX2, new or 8 adjusted channels definitions) remain only valid until the next join of 9 the end-device. Therefore after each successful join procedure the 10 end-device uses the default parameters again and it is up to the 11 network server to re-adjust the values again as needed. 12 5.1 Link Check commands (LinkCheckReq, LinkCheckAns) 13 14 With the LinkCheckReq command, an end-device may validate its connectivity with the 15 network. The command has no payload. 16 When a LinkCheckReq is received by the network server via one or multiple gateways, it 17 responds with a LinkCheckAns command. 18 19 Size (bytes) 1 1 LinkCheckAns Payload Margin GwCnt The demodulation margin (Margin) is an 8-bit unsigned integer in the range of 0..254 20 indicating the link margin in dB of the last successfully received LinkCheckReq command. 21 A value of "0" means that the frame was received at the demodulation floor (0 dB or no 22 margin) while a value of "20", for example, means that the frame reached the gateway 20 dB 23 above the demodulation floor. Value "255" is reserved. 24 The gateway count (GwCnt) is the number of gateways that successfully received the last 25 LinkCheckReq command. 26 5.2 Link ADR commands (LinkADRReq, LinkADRAns) 27 28 With the LinkADRReq command, the network server requests an end-device to perform a 29 rate adaptation. 30 31 Size (bytes) 1 2 1 LinkADRReq Payload DataRate_TXPower ChMask Redundancy 32 Bits [7:4] [3:0] DataRate_TXPower DataRate TXPower 33 The requested date rate (DataRate) and TX output power (TXPower) are region-specific 34 and are encoded as indicated in Chapter 7.The channel mask (ChMask) encodes the 35 channels usable for uplink access as follows with bit 0 corresponding to the LSB: 36 37

Articles in this issue

view archives of Document - LoRaWAN® Specification v1.0.1