Issue link: https://read.uberflip.com/i/1428386
LoRaWAN Specification ©2016 LoRa™ Alliance Page 24 of 91 The authors reserve the right to change specifications without notice. 1 Bit# Usable channels 0 Channel 1 1 Channel 2 .. .. 15 Channel 16 Table 5: Channel state table 2 A bit in the ChMask field set to 1 means that the corresponding channel can be used for 3 uplink transmissions if this channel allows the data rate currently used by the end-device. A 4 bit set to 0 means the corresponding channels should be avoided. 5 6 Bits 7 [6:4] [3:0] Redundancy bits RFU ChMaskCntl NbTrans 7 In the Redundancy bits the NbTrans field is the number of transmissions for each uplink 8 message. This applies only to "unconfirmed" uplink frames. The default value is 1 9 corresponding to a single transmission of each frame. The valid range is [1:15]. If 10 NbTrans==0 is received the end-device should use the default value. This field can be used 11 by the network manager to control the redundancy of the node uplinks to obtain a given 12 Quality of Service. The end-device performs frequency hopping as usual between repeated 13 transmissions, it does wait after each repetition until the receive windows have expired. . 14 Whenever a downlink message is received during the RX1 slot window, it shall stop any 15 further retransmission of the same uplink message. For class A devices, a reception in the 16 RX2 slot has the same effect. 17 The channel mask control (ChMaskCntl) field controls the interpretation of the previously 18 defined ChMask bit mask. It controls the block of 16 channels to which the ChMask applies. 19 It can also be used to globally turn on or off all channels using specific modulation. This field 20 usage is region specific and is defined in Chapter 7. 21 The channel frequencies are region-specific and they are defined in Chapter 6. An end- 22 device answers to a LinkADRReq with a LinkADRAns command. 23 24 Size (bytes) 1 LinkADRAns Payload Status 25 26 Bits [7:3] 2 1 0 Status bits RFU Power ACK Data rate ACK Channel mask ACK 27
