WHITE PAPER
Achieving Full-Spectrum Dominance
mrcy.com 7
The ARES-SAR system is designed to receive pulses from
the SUT and return a modulated pulse that simulates a pulse
reflected from the ground. To achieve this, the system first
down-converts the incoming pulse from RF to an intermediate
frequency before modulating with the projection database
coefficients. The typical transmitted waveform is a linear
frequency modulated (LFM, or chirp) signal. Figure 2.3 provides
a top-level block diagram of the ARES-SAR system.
A GUI handles the actual operation and interface with the
ARES-SAR system. Test scenarios are pre-scripted. All SUT
platform flight parameters—heading, synthetic aperture start
and stop GPS locations, velocity, altitude, and pulse repetition
interval (PRI) —are predetermined. An amplitude-only data file
captures image data representing the mapped area.
The GUI allows for entry of these parameters and provides
overall test setup and system operation connectivity. In
addition, the GUI allows the user to specify the center
frequency of the chirp signal, within the range of 2–18 GHz,
with a resolution of 1 KHz. Based on the entered/captured
information and the image data file, the GUI calculates the
projection database coefficients for the scenario and stores
them for later playback.
Other features include event logging, automated calibration, BIT
functionality, range attenuation based on the platform's range
to the ground patch scene center, and the pulse present output
signal generated by the control/SAR processor unit, to gate the
output RF pulse to improve signal-to-noise performance.
Detect Incoming Radar
Pulse and Trigger on
Leading Edge
RF Down-conversion Apply Range Delay
RF Up-conversion Apply Doppler
Modular Incoming
Radar Pulse With Projection
DataBase Coefficients
Transmit Modulated
Signal
System Under Test
Pulse From
System Under Test
Figure 2.3: Block diagram of algorithm to calculate projection database coefficients.