Issue link: https://read.uberflip.com/i/1520579
WHITE PAPER Achieving Full-Spectrum Dominance mrcy.com 5 SAVING $3 MILLION IN FLIGHT TEST COSTS ARES has saved millions of dollars in flight test costs for radar developers. A cost comparison of tests in the air and in an anechoic chamber from a customer shows the savings possible for flight testing. Tested Radar Mode Flight Test Cost Chamber Test Cost Cost Savings Per Day Air-to-ground 1 blue airplane versus 1 ground target $251,000 $17,000 $234,000 Air-to-air 1 blue airplane versus 1 red airplane $331,000 $17,000 $314,000 Based on these numbers, the cost of flight testing a radar once per month for a year using the lower air-to-ground testing cost ($251,000 × 12 months) is $3 million. Doing this in a chamber with ARES would have cost $204,000, saving the customer $2.8 million. The actual cost savings may be higher for some radar developers if they rent airplanes and airspace or flight test more than once per month. GAINING A WIDE SPECTRUM VIEW WITH DIRECT RF Figure 1: Mercury offers a range of direct RF technology and RF/microwave components used to build DRFM and other EW subsystems. Direct RF technology has improved DRFM performance and enabled EW systems to be deployed faster. Until the past few years, analog-to-digital (A/D) and D/A converters operated at sampling rates that were below the RF frequencies used by many radar systems. This required analog circuitry at the front end to shift the frequency of received signals down to a range where the A/D converter could digitize it. In the case of D/A converters, the analog circuitry would shift the frequency up from the output of the D/A converter to an RF frequency needed by the radar system for transmitting. Newer data converters have increased sample rates that can digitize RF signals directly, eliminating the need for additional analog circuitry. Systems with direct RF sampling have several distinct advantages over those using analog front ends. In applications where signals might be hopping between different frequencies, direct RF removes delays associated with having analog circuitry that tunes and re-tunes to frequencies of interest. The wide bandwidth of the direct RF converters "see" the entire sampled spectrum instantaneously, lowering the possibility of missing fast-moving signals. Current direct RF A/D and D/A converters can operate at samples rates of up to 64 gigasamples per second with 10-bit resolution, enabling the direct sampling of signals up to Ka band. Advances in integrated circuit (IC) packaging and design have improved performance while reducing size. Newer direct RF solutions consist of a single IC and a data processing engine such as an FPGA, with the A/D and D/A converters in the same IC package. Having converters on the same silicon, or at least intimately connected to it, lowers the latency of data processing. This latency can often be an order of magnitude less than solutions with discrete ICs connected to the FPGA IC. Low latency directly impacts performance in many DRFM applications; integrating a processor/converter saves size, weight, and power (SWaP), reducing thermal management requirements from heatsinks and cooling solutions. NEED PRODUCT PHOTO FROM ATLANTA MICRO

