PRE OPERATION
1. Inspect and prepare the workspace: inspect workpiece for loose knots, splits, defects and foreign objects.
2. Prepare the workspace: clear the work area and table except for the workpiece.
3. Verify belt tracking and tightness: set to correct height and position and lock them in.
4. Check the abrasive: ensure abrasive belt is in good working condition prior to use.
5. Adjust table angle: adjust tilt table to the desired angle as per manufacturer instructions.
6. Start the dust collector: turn on dust collection system and ensure it is working appropriately.
REQUIRED PPE
Safety Glasses Hearing Protection Dust Mask
Always wear all required PPE
PRECAUTIONS
1. Inspect equipment - Do not use if equipment is damaged.
2. Inspect guards/shields - Do not use if guards/shields are missing or damaged.
3. Secure long hair, ensure no loose clothing, remove jewelry, no gloves while
machine is in operation.
4. Do not sand workpiece that is too small to be safely supported or held.
HAZARDS
Cuts
Entanglement
Dust
Burns
Noise
Pinch point
Flying debris
Abrasions
Report any issues or findings to your supervisor immediately
!
Only use equipment if you are trained and authorised to do so.
Refer to user manual for additional information including set up, maintenance and instructions for use.
WSPS.CA
BELT SANDER SAFE WORK PROCEDURE
