PRE OPERATION
1. Prepare the workspace: clear the table except for the workpiece or stock.
2. Inspect the workpiece: inspect for loose knots, splits, defects, and foreign objects.
3. Support the workpiece: use extension tables or rollers to support larger workpieces.
4. Adjust rip fence: if rip cutting set to correct position and lock in place, while powered off.
5. Set the miter gauge: if cross cutting, set the miter gauge as per manufacturer's instructions with an
extension fence. Never use rip fence for crosscuts.
6. Check the blade: use the proper blade for the type of work and ensure it is sharp and undamaged.
7. Set the blade: while powered off, set the blade to the appropriate height above the workpiece.
8. Start dust collector: turn on the dust collection system and ensure its working appropriately.
REQUIRED PPE
Safety Glasses Hearing Protection
Always wear all required PPE
PRECAUTIONS
1. Inspect equipment - Do not use if equipment is damaged.
2. Inspect guards/shields - Do not use if guards/shields are missing or damaged.
3. Keep blades clean and sharp.
4. Tie back long hair, ensure no loose clothing, remove jewelry, no gloves while
machine is in operation.
HAZARDS
Cuts
Entanglement
Dust
Noise
Flying debris
Kickback
Pinch point
Burns
Report any issues or findings to your supervisor immediately
!
Only use equipment if you are trained and authorised to do so.
Refer to user manual for additional information including set up, maintenance and instructions for use.
WSPS.CA
TABLE SAW WORK PROCEDURE
