Issue link: https://read.uberflip.com/i/1540208
Regional Parameters RP002-1.0.5 ©2022-2025 LoRa Alliance ® Page 50 of 116 The authors reserve the right to change specifications without notice. 3.7.3 EU433 Data Rate and End-Device Output Power Encoding 961 There is no dwell time limitation for the EU433 PHY layer. The TxParamSetupReq MAC 962 command is not implemented by EU433 devices. 963 The following encoding is used for Data Rate (DR) in the EU433 band: 964 965 Data Rate Configuration Indicative Physical Bit Rate [bit/s] 0 LoRa: SF12 / 125 kHz 250 1 LoRa: SF11 / 125 kHz 440 2 LoRa: SF10 / 125 kHz 980 3 LoRa: SF9 / 125 kHz 1760 4 LoRa: SF8 / 125 kHz 3125 5 LoRa: SF7 / 125 kHz 5470 6 LoRa: SF7 / 250 kHz 11000 7 FSK: 50 kbps 50000 8..11 RFU 12 LoRa: SF6 / 125 kHz 9375 13 LoRa: SF5 / 125 kHz 15625 14 RFU 15 Defined in [TS001] 3 Table 30: EU433 data rate and TXPower 966 967 Data Rates DR12 and DR13 are allowed for use in EU433 since version RP002-1.0.5. 968 EU433 end-devices SHALL support the first of the following data rate options plus any 969 combination of the other data rate options: 970 1. DR0 to DR5 (minimum set supported for certification, REQUIRED to support) 971 2. DR6 (an additional data rate that MAY be supported) 972 3. DR7 (an additional data rate that MAY be supported) 973 4. DR12 to DR13 (an additional pair of data rates that MAY be supported) 974 For each of the listed options, all data rates in the range specified SHALL be implemented 975 exactly as listed (meaning no listed data rate can be left unimplemented). 976 The list of data rates supported by the end-device SHOULD be communicated, as part of the 977 device profile, to the Network Server, using an out-of-band channel during the end-device 978 commissioning process. 979 980